IR
These commands are available three ways — in the FREE-WILi GUI app, in a serial terminal, and on the device itself. See Connecting it to a computer for how to reach them.
Stream IR
Enables or disables streaming of received IR codes to the host.
How to use it — press o. At the prompt, enter: 1 to enable 0 to disable.
What you enter — enable.
Send IR
Transmits a 4-byte IR code.
How to use it — press a. At the prompt, enter: 4 byte IR code in hex.
What you enter — ir_code.
IR Self Test
Transmits one frame per supported protocol and checks that the on-board receiver decodes each one back. Takes a few seconds and emits infrared.
How to use it — press t.
List IR Dir
Lists the directories and .ir files on the SD card, directories first. Empty path lists \ir.
How to use it — press l. At the prompt, enter: Directory to list, empty for \ir.
What you enter — path.
List IR Buttons
Lists the buttons in one Flipper .ir file with the index each one is sent by. Malformed entries are counted as skipped, not listed.
How to use it — press b. At the prompt, enter: Path of a .ir file.
What you enter — path.
Send IR Button
Transmits one button from a .ir file, repeated by the IR Repeat setting. Emits infrared.
How to use it — press s. At the prompt, enter: Button index then the .ir file path.
What you enter — index, path.
Save IR Capture
Appends the last received signal to \ir\learned.ir under this name, decoded when the protocol was recognised and as raw timings when it was not.
How to use it — press c. At the prompt, enter: Name for the captured signal.
What you enter — name.
IR Status
Reports the IR engine's carrier, repeat count, capture overruns and whether the \ir\ tree exists on the card.
How to use it — press i.
IR Carrier
Default transmit carrier frequency. Only these four are legal; a .ir raw entry with its own frequency line overrides this for that entry.
How to use it — press f.
What you enter — value.
IR Repeat
How many times Send IR Button transmits each frame, 1 to 5, with a 40 ms gap between repeats.
How to use it — press r.
What you enter — value.